Issue 23, 2015

p-Type conducting transparent characteristics of delafossite Mg-doped CuCrO2 thin films prepared by RF-sputtering

Abstract

The growth of technologically relevant compounds, Mg-doped CuCrO2 delafossite thin films, on a quartz substrate by radio-frequency sputtering is reported in this work. The deposition, performed at room temperature, leads to a nanocrystalline phase with extremely low roughness and high density. Delafossite characteristic diffraction peaks were obtained as a function of the thermal treatment under primary vacuum. The electrical conductivity was optimized until 1.6 S cm−1 with an optical transmittance of 63% in the visible range by a 600 °C annealing treatment under primary vacuum applied for 4 h. The transport properties were analyzed by Seebeck and Hall measurement, integrated spectrophotometry and optical simulation. These measurements highlighted degenerated semiconductor behavior using a hopping mechanism with a high hole concentration (1021 cm−3) and a low mobility (0.2 cm2 V−1 s−1). The direct optical bandgap of 3.3 eV has been measured according to Tauc's relationship. A refractive index of 2.3 at a wavelength of 1100 nm has been determined by spectroscopic ellipsometry and confirmed by two independent modellings of the optical transmittance and reflectance spectra. All these p-type TCO optoelectronic characteristics have led to the highest Haacke's figure of merit (1.5 × 10−7 Ω−1) reported so far for such delafossite materials.

Graphical abstract: p-Type conducting transparent characteristics of delafossite Mg-doped CuCrO2 thin films prepared by RF-sputtering

Article information

Article type
Paper
Submitted
16 Apr 2015
Accepted
05 May 2015
First published
05 May 2015

J. Mater. Chem. C, 2015,3, 6012-6024

Author version available

p-Type conducting transparent characteristics of delafossite Mg-doped CuCrO2 thin films prepared by RF-sputtering

A. Barnabé, Y. Thimont, M. Lalanne, L. Presmanes and P. Tailhades, J. Mater. Chem. C, 2015, 3, 6012 DOI: 10.1039/C5TC01070E

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements