Issue 39, 2018

Photoluminescence, radioluminescence and thermoluminescence properties of Eu3+ doped cadmium tantalate phosphor

Abstract

For investigate spectroscopic properties, Eu3+ doped columbite type CdTa2O6 phosphors were synthesized using the solid state reaction method. The synthesized ceramic phosphors were investigated by X-ray diffraction (XRD), scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS), photoluminescence (PL), radioluminescence (RL) and thermoluminescence (TL) analyses. CdTa2O6:Eu3+ phosphors exhibited emissions at 591.8 nm and 612.1 nm because of the characteristic band transitions of the Eu3+ ion. Phosphor emission increased with increasing Eu3+ ion dopant up to 1.5 mol%, and then decreased owing to concentration quenching. The decay times decreased with increasing Eu3+ dopant, while they were varied from 711 to 534 μm. The scintillation emissions of Eu3+ doped samples from the UV to near-IR spectral region were monitored by RL measurements. The high RL emission may be attributed to the good scintillation property of phosphor. TL glow curves were monitored for different Eu3+ concentrations in the range of 50 °C to 400 °C at a heating rate of 2 °C s−1, after being irradiated under short-wave UV light (254 nm).

Graphical abstract: Photoluminescence, radioluminescence and thermoluminescence properties of Eu3+ doped cadmium tantalate phosphor

Article information

Article type
Paper
Submitted
11 Jun 2018
Accepted
04 Sep 2018
First published
04 Sep 2018

Dalton Trans., 2018,47, 13939-13948

Photoluminescence, radioluminescence and thermoluminescence properties of Eu3+ doped cadmium tantalate phosphor

M. İlhan and İ. Ç. Keskin, Dalton Trans., 2018, 47, 13939 DOI: 10.1039/C8DT02395F

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements