Issue 5, 2019

Interfacial friction-induced electronic excitation mechanism for tribo-tunneling current generation

Abstract

Direct-current (d.c.) electricity generation using a moving Schottky contact is emerging as a new strategy for mechanical energy conversion. Here, we demonstrate the generation of d.c. tunneling current with a density of ∼35 A m−2 at a metal–insulator–semiconductor (MIS) sliding system using micro-tips. The measured current densities were found to be two to three orders of magnitude higher than that observed with the conventional polymer-based triboelectric nanogenerators (TENGs). The electromotive force ΔVs* for the tribo-tunneling transport comes from the dynamic electronic excitation at the frictional interface rather than from the electrostatically trapped surface charges as in the case of conventional TENGs. The strong electronic excitation can give rise to a non-equilibrium interfacial charge variation Δσm. Depending on the energy distribution of the excited electrons/holes, Δσm subsequently dissipates non-adiabatically into tunneling current and trapped surface charges, or adiabatically into heat. These fundamental results not only enhance our understanding of the triboelectric phenomenon, but also open up new paths for the development of next-generation mechanical energy harvesting and sensing techniques.

Graphical abstract: Interfacial friction-induced electronic excitation mechanism for tribo-tunneling current generation

Supplementary files

Article information

Article type
Communication
Submitted
05 Oct 2018
Accepted
04 Feb 2019
First published
04 Feb 2019

Mater. Horiz., 2019,6, 1020-1026

Interfacial friction-induced electronic excitation mechanism for tribo-tunneling current generation

J. Liu, K. Jiang, L. Nguyen, Z. Li and T. Thundat, Mater. Horiz., 2019, 6, 1020 DOI: 10.1039/C8MH01259H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements