Issue 1, 2022

Oleic acid induced tailored morphological features and structural defects in CuO for multifunctional applications

Abstract

Synergistically tuned noble metals and intentionally formed complex heterostructured nanomaterials can enhance the required application effectiveness but at the cost of tedious synthesis routes, expensive chemicals, and sophisticated instruments. To overcome such demerits, herein, we report on the oleic acid-mediated convenient co-precipitation route using water–hexane as a biphasic solvent for CuO synthesis in the form of nano feathers (CuO-NF), solid/hollow hexagonal thin sheets (CuO-HS), and mega sheets (CuO-MS) at room temperature. The exotic CuO nanoarchitectures achieved were tested and compared with control samples (CuO-IS) for CO2 sensing, natural sunlight induced dye degradation, and catalytic CO2 reduction. Among the various CuO nanostructures synthesized, CuO-HS depicted higher oxygen deficiency, electronic conductivity, and visible light absorption. Most of the solid/hollow hexagonal thin sheets depicted an edge length in the 50–350 nm range with an observed thickness as low as 5 nm. The CuO-HS microsensor demonstrated ultrasensitivity (Rg/Ra = ∼85), dominant selectivity (>6 gases), repeatability (98.7%), CoV (1.3%), and LoD (4.3 ppm) at 32 °C towards CO2 in 20–5000 ppm. The role of structural defects in sensing was confirmed from operando UV-Vis-DRS & PL. Rapid dye degradation in natural sunlight shown by CuO-HS was primarily attributed to the lower charge reunification. Additionally, CuO-HS facilitated methanol formation within 3 h at a rate of 53 and 18 μmol g−1 in the presence of artificial solar and natural sunlight, respectively. Dye degradation and CO2 photoreduction pathways were probed using HPLC and GC-MS, respectively.

Graphical abstract: Oleic acid induced tailored morphological features and structural defects in CuO for multifunctional applications

Supplementary files

Article information

Article type
Paper
Submitted
09 Sep 2021
Accepted
27 Oct 2021
First published
27 Oct 2021
This article is Open Access
Creative Commons BY-NC license

Mater. Adv., 2022,3, 418-436

Oleic acid induced tailored morphological features and structural defects in CuO for multifunctional applications

A. Kulkarni, M. Satbhai, W. Li, D. Bornare, K. Syed and S. Joshi, Mater. Adv., 2022, 3, 418 DOI: 10.1039/D1MA00827G

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements