Utpal
Das
,
Yi-Ling
Tsai
and
Wenwei
Lin
*
Department of Chemistry, National Taiwan Normal University, 88, Section 4, Tingchow Road, Taipei 11677, Taiwan, R.O.C. E-mail: wenweilin@ntnu.edu.tw; Fax: (+886) 229324249; Tel: (+886) 277346131
First published on 22nd October 2012
An organocatalytic asymmetric synthesis of spironitrocyclopropanes has been demonstrated starting from 2-arylidene-1,3-indandiones and bromonitroalkanes catalyzed by a cinchona-derived bifunctional organocatalyst. The products were obtained with excellent enantioselectivities, diastereoselectivities and with good yields.
In recent years, organocatalytic asymmetric cyclopropanation reactions were found to be an attractive alternative, and many elegant strategies were reported.10 However, the direct organocatalytic synthesis of spirofused nitrocyclopropanes is very limited10a,d and that employing 2-arylidene-1,3-indandiones (1) has not yet been reported. The substrates 1 are known as a restricted class of trisubstituted electron poor alkenes and have rarely been used in organocatalysis.11 Very recently, Lattanzi and co-workers11a described an elegant Michael-initiated cascade reaction to prepare spirocyclopropanes starting from 1. However, their attempted base-catalyzed cyclopropanation of 1 with bromonitromethane (2) was not successful. As evident in the literature,10a,d cinchona alkaloid derived thioureas12 are well known for their bifunctional behavior to activate electron poor alkenes and pronucleophiles simultaneously. Accordingly, we planned to use bifunctional catalysts (I–IV) for our study of nitrocyclopropanation. Thiourea catalysts V–VI derived from cyclohexane diamine were also included for our study. In a continuation of our recent efforts,13 herein we wish to report our attempts to prepare enantioenriched spironitrocyclopropane derivatives.14 We began our study by using 1a (alkene component) and bromonitromethane (2a, pronucleophile) as the model reaction partners in the presence of quinidine derived bifunctional tertiary amine-thiourea catalyst I. Na2CO3 was used to neutralize the liberated HBr. However, our initial attempt at the predicted nitrocyclopropanation was unsuccessful, and only a trace amount of the expected product was detected (Table 1, entry 1). We reasoned that this failure was due to a lack of hydrogen-bond interactions between the N–H bonds of thiourea and the 1,3-dicarbonyl groups of 1a. Water is well known for its ability to participate in hydrogen bonding interactions and many organocatalytic reactions are known to proceed in water.15 Unfortunately, we did not observe any conversion of starting material when the reaction was conducted in water (entry 2). To our surprise, we noted that precise quantities of water were critical for the reaction to proceed. In the presence of one equivalent of water the reaction proceeded smoothly to furnish the nitrocyclopropanation adduct (3a) in 49% isolated yield in just two hours with 75% ee at room temperature (entry 3). Lowering of the reaction temperature to 0 °C was beneficial as product 3a was obtained in 76% yield with a diasteremeric ratio of 11:1 and 91% enantiomeric excess (entry 4).
Entry | Cat. | Solvent | t (h) | 3a (%) | drc | eed (%) |
---|---|---|---|---|---|---|
a Reaction conditions: 1a (0.1 mmol), 2a (1.5 equiv.), cat. (20 mol%), base (1 equiv.) in 0.5 mL anhydrous solvent. b Isolated yield. c Diastereomeric ratio was determined by 1H NMR spectroscopic analysis of the crude reaction mixture. d Enantiomeric excess was determined by HPLC analysis. e At room temperature. f No water was used as an additive. g NaHCO3 was used. h The reaction was performed at −20 °C in 0.2 mL toluene. i 10 mol% I was used. | ||||||
1e,f | I | Toluene | 24 | — | — | — |
2e | I | H2O | 24 | — | — | — |
3e | I | Toluene | 2 | 49 | 6.5:1 | 75 |
4 | I | Toluene | 5 | 76 | 11:1 | 91 |
5 | II | Toluene | 5 | 69 | 11:1 | −91 |
6 | III | Toluene | 5 | 65 | 10:1 | −88 |
7 | IV | Toluene | 6 | 79 | 12:1 | −75 |
8 | V | Toluene | 48 | 49 | — | ± |
9 | VI | Toluene | 30 | 49 | — | ± |
10 | I | CH2Cl2 | 6 | 78 | 6.5:1 | 87 |
11 | I | THF | 6 | 64 | 4.3:1 | 67 |
12g | I | Toluene | 48 | 49 | 11:1 | 90 |
13h | I | Toluene | 6 | 79 | 19:1 | 94 |
14h,i | I | Toluene | 14 | 79 | 16:1 | 88 |
Encouraged by this promising output, we also evaluated other cinchona alkaloid derived catalysts (II–IV) and catalysts V–VI, and the results are presented in Table 1 (entries 5–9). Although all the catalysts (I–IV) could promote the reaction, catalyst I was found to be better in terms of chemical yield and enantioselectivity. However catalysts V and VI turned to be very poor, as not only did the reaction take longer (<70% conversion in the indicated time), but also the obtained products were racemic. The organocatalytic nitrocyclopropanation reaction for the formation of 3a was then further optimized. A number of different solvents and bases were screened (entries 10–13, for details see ESI†), and the results indicate that proper choice of solvent and base play an important role. Adduct 3a was afforded in reduced diastereoselectivity and enantioselectivity when the reaction was conducted in dichloromethane or tetrahydrofuran (entries 10 and 11). Product 3a could be formed with a similar product profile (entry 12) using the weaker sodium bicarbonate base, but the progress of reaction was too slow. When the reaction temperature was further lowered to −20 °C, 3a was furnished in 94% ee coupled with 19:1 diastereoselectivity and 79% yield (entry 13). It is worth mentioning that both the diastereoselectivity and enantioselectivity of 3a dropped upon lowering of catalyst loading (10 mol%) under these reaction conditions (entry 14).
With an effective protocol for the enantioselective formation of spironitrocyclopropane in hand, the substrate scope and generality of the methodology were examined. A variety of substituents on 2-arylidene-1,3-indandiones (1a–l) and different bromonitroalkanes (2a–c) could be employed to provide spironitrocyclopropanes (3a–n) in good yields (up to 88%), excellent diastereoselectivities (up to 19:1) and enantioselectivities (up to 98%) (Table 2). The electronic nature, bulkiness or positions of substituents in the aryl group seems to have little effect on the results (entries 1–10). Slightly reduced enantioselectivities were observed in the cases of 4-nitrophenyl and 3-fluorophenyl substituted arylidene-1,3-indandiones (1c and 1f). We have also evaluated substituted bromonitroalkanes (2b and 2c) as pronucleophile (entries 11–14) for synthesis of the products 3k–n bearing a quaternary stereocenter, which is considered a challenging task in organic synthesis.16 Thus the reaction of 1-bromo-1-nitroethane (2b) with substituted 2-arylidene-1,3-indandiones having different electronic natures proceeded smoothly to give the desired products (3k–m) in good yields, excellent diastereoselectivities and enantioselectivities (entries 11–13). It is noteworthy that the reaction between 1-bromo-1-nitropropane (2c) and 1a was slower and the product (3n) was obtained in moderate enantioselectivity (56%) albeit with good yield and diastereoselectivity (entry 14 vs. 1 and 11). Less reactive cyclohexyl substituted alkylidene-1,3-indandiones were also examined with 2a. However, a poor result was obtained under our reaction conditions (entry 15).17 Additionally, cyclopropanation of 4-methoxyphenyl substituted arylidene-1,3-indandione (1l) and 2a did not take place under identical reaction conditions (entry 16).18 The absolute configuration of 3a and 3k were determined by single crystal X-ray data analyses and those of the others were assigned by analogy.19
Entry | R1 | R2 | t (h) | 3,b (%) | drc | eed (%) |
---|---|---|---|---|---|---|
a Reaction conditions: 1a–l (0.1 mmol), 2a–c (1.5 equiv.), I (20 mol%), Na2CO3 (1 equiv.) in 0.2 mL anhydrous toluene. b Isolated yield. c Determined by 1H NMR spectroscopic analysis of the crude reaction mixture. d ee for the major isomer (ee after single recrystallization). e A mixture of three compounds (70% ee, 87% ee and 72% ee) were obtained (please also see ESI†). | ||||||
1 | 4-BrC6H4 | H | 6 | 3a, 79 | 19:1 | 96 (>99) |
2 | 4-ClC6H4 | H | 8 | 3b, 68 | 19:1 | 95 |
3 | 4-NO2C6H4 | H | 8 | 3c, 68 | 18:1 | 86 |
4 | 4-CNC6H4 | H | 12 | 3d, 78 | 19:1 | 92 |
5 | 2-BrC6H4 | H | 8 | 3e, 68 | 19:1 | 96 (>99) |
6 | 3-FC6H4 | H | 7 | 3f, 71 | 16:1 | 86 |
7 | C6H5 | H | 10 | 3g, 78 | 18:1 | 96 |
8 | 4-MeC6H4 | H | 5 | 3h, 68 | 18:1 | 96 |
9 | 2-MeC6H4 | H | 5 | 3i, 65 | 18:1 | 96 |
10 | 4-tBuC6H4 | H | 6 | 3j, 63 | 18:1 | 98 |
11 | 4-BrC6H4 | Me | 12 | 3k, 81 | 19:1 | 96 (>99) |
12 | C6H5 | Me | 24 | 3l, 88 | 19:1 | 93 |
13 | 4-MeC6H4 | Me | 36 | 3m, 78 | 19:1 | 96 |
14 | 4-BrC6H4 | Et | 72 | 3n, 65 | 16:1 | 56 |
15e | Cyclohexyl | H | 8 | — | — | — |
16 | 4-OMeC6H4 | H | 24 | — | — | — |
We believe that the reaction proceeds through simultaneous activation of the pronucleophile (bromonitroalkane) and electrophilic 2-arylidene-1,3-indandiones via water assisted H-bonding interaction by the bifunctional catalyst. Nucleophilic addition of bromonitroalkane and subsequent intramolecular cyclisation furnished the desired spirocyclopropane products (see ref. 10d).
Furthermore, we envisioned that spirocyclopropane product (3g) can also be accessed by employing bromonitrostyrene, such as 4, as a dielectrophilic component10a,20 and 1,3-indandione (5) as a dinucleophile in presence of appropriate catalyst. However, our initial attempt to use the present optimized reaction conditions was not very successful and the adduct ent-3g was obtained with only 35% ee and moderate yield (57%) (Scheme 1).
Scheme 1 Synthesis of ent-3g starting from 4 and 5. |
In summary, we have developed an efficient asymmetric pathway for the preparation of spironitrocyclopropanes catalyzed by cinchona-derived bifunctional organocatalysts. To the best of our knowledge, this is the first asymmetric route to prepare spironitrocyclopropanes starting from 2-arylidene-1,3-indandiones and bromonitroalkanes. The products were obtained in good yields (up to 88%), excellent enantioselectivities (up to 98%) and diastereoselectivities (up to 19:1). Further investigation of the synthetic route described in Scheme 1, biological evaluation of spironitrocyclopropanes and investigation of the reaction mechanism are currently underway in our laboratory.
Footnote |
† Electronic supplementary information (ESI) available: Experimental procedure, spectral data of new compounds. CCDC 892806 (3a) and 892808 (3k). For ESI and crystallographic data in CIF or other electronic format see DOI: 10.1039/c2ob26943k |
This journal is © The Royal Society of Chemistry 2013 |