Issue 7, 2020

Atomic layer deposition and electrospinning as membrane surface engineering methods for water treatment: a short review

Abstract

With the development of water purification, membrane processes have drawn attention because of their separation efficiency. However, low rejection efficiency and flux decline driven by membrane fouling remain as challenges. Accordingly, the surface modification of membranes has been widely adopted to enhance membrane processes. For example, the conventional method of sol–gel coating has been mostly used to form a functional top layer that can prevent the accumulation/adsorption of foulants. This conventional method is limited to designing the physico-chemical properties of membranes in a precise manner to achieve an enhanced membrane performance. One advanced method is atomic layer deposition, in which a uniform metal oxide layer is coated at the atomic level. Because of its precise control of the metal oxide layer thickness, it has been mainly applied for tuning the pore structure and/or surface hydrophilicity of membranes. It consequently enhances the rejection efficiency and alleviates fouling by engineering the membrane surface chemistry. The fabrication of an electrospun nanofiber via electrospinning is another approach that has been applied to modify the physico-chemical properties of membranes. It engineers the surface chemistry of membranes (e.g., hydrophilicity/hydrophobicity and surface roughness) by integrating a specific nanomaterial into the electrospun nanofiber. Electrospinning enables porosity tuning by controlling the variations of the fabrication protocol. Despite many studies on membrane surface modification, review articles on the technological progress and the challenges encountered by these functionalization methods are lacking. This review article provides the following: i) an introduction of the nanomaterials (e.g. graphene based nanomaterials, carbon nanotubes and titanium dioxide) and three methods for surface modification; ii) a systematic summary of their application in ALD and electrospinning, and in membrane processes for water treatment; and consequently iii) insight into the technological challenges and future perspectives for their wider application in the membrane industry.

Graphical abstract: Atomic layer deposition and electrospinning as membrane surface engineering methods for water treatment: a short review

Article information

Article type
Critical Review
Submitted
26 Dec 2019
Accepted
16 Apr 2020
First published
16 Apr 2020

Environ. Sci.: Water Res. Technol., 2020,6, 1765-1785

Atomic layer deposition and electrospinning as membrane surface engineering methods for water treatment: a short review

J. Lee, I. S. Kim, M. Hwang and K. Chae, Environ. Sci.: Water Res. Technol., 2020, 6, 1765 DOI: 10.1039/C9EW01134J

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements