Issue 4, 2013

In situgelation of aqueous solutions of entangled poly(vinyl alcohol)

Abstract

Rheological behaviour of poly(vinyl alcohol) (PVA) aqueous systems was systematically investigated at 30 °C for different concentrations, molecular weights and hydrolysis degrees. The viscosity of very dilute polymer solutions was studied by means of viscometry, while the concentrated solutions were analyzed by steady shear flow measurements. The limit between the entangled and non-entangled states of PVA aqueous solutions was determined as the crossover of two scaling laws describing the dependence of specific viscosity as a function of coil overlap parameter, c[η]. Then, physical gels with good elastic properties were prepared in situ by freezing/thawing/ageing (200 min per cycle) of entangled PVA solutions. The influence of each stage of the applied cryogenic treatment on the gel formation and elastic properties of the final network was followed by means of dynamic rheological measurements at low strain, in the linear domain of viscoelasticity. It was shown that the gel properties largely depend on the initial state of PVA solutions, as described by the c[η] value, and on the degree of hydrolysis, as well as on the thermal history, i.e., the number of cryogenic cycles, thawing rate, and ageing step. For a given coil overlap parameter, the elastic modulus of cryogels tends to a limiting value, which can be reached faster by adding an ageing sequence to the classical freezing/thawing cryogenic cycles. This maximum value of the elastic modulus increases with increasing the coil overlap value of the initial solution.

Graphical abstract: In situ gelation of aqueous solutions of entangled poly(vinyl alcohol)

Article information

Article type
Paper
Submitted
10 May 2012
Accepted
07 Nov 2012
First published
28 Nov 2012

Soft Matter, 2013,9, 1244-1253

In situ gelation of aqueous solutions of entangled poly(vinyl alcohol)

M. Bercea, S. Morariu and D. Rusu, Soft Matter, 2013, 9, 1244 DOI: 10.1039/C2SM26094H

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements