Issue 32, 2014

Enhanced emission from ZnO-based double heterostructure light-emitting devices using a distributed Bragg reflector

Abstract

Double hetero-structured n-Mg0.13Zn0.87O/i-ZnO/p-Mg0.13Zn0.87O light-emitting devices (LEDs) have been fabricated, and the p-type Mg0.13Zn0.87O layer was obtained via a lithium–nitrogen codoping method. Obvious emission at around 400 nm has been observed from the LEDs under forward bias. To increase the light extraction from the LEDs, a distributed Bragg reflector whose reflectivity is 98% at 400 nm was bonded on the back side of the device, and the emission of the device was enhanced by around 1.6 times with the reflector.

Graphical abstract: Enhanced emission from ZnO-based double heterostructure light-emitting devices using a distributed Bragg reflector

Additions and corrections

Article information

Article type
Communication
Submitted
24 Feb 2014
Accepted
17 Mar 2014
First published
21 Mar 2014

RSC Adv., 2014,4, 16578-16582

Author version available

Enhanced emission from ZnO-based double heterostructure light-emitting devices using a distributed Bragg reflector

Y. Lu, C. Shan, M. Jiang, B. Li, K. Liu, R. Li and D. Shen, RSC Adv., 2014, 4, 16578 DOI: 10.1039/C4RA01585A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements