Issue 32, 2017

Robust, double-shelled ZnGa2O4 hollow spheres for photocatalytic reduction of CO2 to methane

Abstract

Robust, double-shelled ZnGa2O4 hollow spheres were successfully fabricated by hydrothermally treating an aqueous solution containing Zn(II), Ga(III), and citric acid, followed by annealing at 600 °C, 700 °C, or 800 °C in air to remove the carbon species. The hollow structure is expected to trap incident photons to enhance the light absorbance. The sample annealed at 700 °C exhibited the optimized photocatalytic performance in the reduction of CO2 in the presence of water vapor to methane. This property is ascribed to the improved crystallinity of the sample, which has fewer defect centers for the recombination of electron–hole pairs compared with that annealed at 600 °C. The reduced performance of the sample done at 800 °C relative to the one annealed at 700 °C is attributed to the formation of additional impurities besides ZnGa2O4, possibly due to partial Zn(II) evaporation at higher temperature leading to segregation of potential Ga-based oxides. RuO2 and Pt were loaded onto the sample surface to greatly enhance the photocatalytic performance. The best photocatalytic performance was observed in the sample co-loaded with Pt and RuO2.

Graphical abstract: Robust, double-shelled ZnGa2O4 hollow spheres for photocatalytic reduction of CO2 to methane

Article information

Article type
Paper
Submitted
10 Dec 2016
Accepted
06 Jan 2017
First published
06 Jan 2017

Dalton Trans., 2017,46, 10564-10568

Robust, double-shelled ZnGa2O4 hollow spheres for photocatalytic reduction of CO2 to methane

Y. Zhang, P. Li, L. Tang, Y. Li, Y. Zhou, J. Liu and Z. Zou, Dalton Trans., 2017, 46, 10564 DOI: 10.1039/C6DT04668A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements