Issue 6, 2022

Investigation of matrix independent calibration of oxygen in glow discharge optical emission spectrometry

Abstract

The performance of glow discharge optical emission spectrometry for matrix independent oxygen determination was investigated using the spectral lines of atomic oxygen at 130 nm and 777 nm and standard conditions for dc discharge with a 4 mm anode (700 V, 20 mA). Using hot-pressed calibration samples of Cu-, Al- and Mg-powder mixed with their oxides, at 130 nm the dependence of the emission yield on these matrices was confirmed. However, at 777 nm oxygen has the same emission yield in these matrices. In order to compare the emission yield of oxygen with the emission yield in iron a thick 43 μm FeO-layer was prepared and characterized by Rutherford backscattering spectrometry, X-ray diffraction and glow discharge optical emission spectrometry. At 130 nm, the emission yield of oxygen in FeO is most similar to that in an Al-matrix. At 777 nm, the calibration revealed a higher emission yield of oxygen in FeO in comparison to the common emission yield of oxygen in Cu-, Al- and Mg-matrices.

Graphical abstract: Investigation of matrix independent calibration of oxygen in glow discharge optical emission spectrometry

Article information

Article type
Paper
Submitted
10 2 2022
Accepted
28 4 2022
First published
28 4 2022
This article is Open Access
Creative Commons BY license

J. Anal. At. Spectrom., 2022,37, 1223-1228

Investigation of matrix independent calibration of oxygen in glow discharge optical emission spectrometry

V. Hoffmann, B. Gebel, R. Heller and T. Gemming, J. Anal. At. Spectrom., 2022, 37, 1223 DOI: 10.1039/D2JA00043A

This article is licensed under a Creative Commons Attribution 3.0 Unported Licence. You can use material from this article in other publications without requesting further permissions from the RSC, provided that the correct acknowledgement is given.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements