Issue 30, 2012

Simple and green synthesis of monodisperse silver nanoparticles and surface-enhanced Raman scattering activity

Abstract

We describe a simple and green method for preparing silver nanoparticles with an average diameter in the range from 4.0 nm to 5.0 nm and with the standard deviation as low as 0.3 nm (polydispersity: 5.5%). The pre-synthesized silver oleate precursor in oleic acid was thermally reduced to obtain the monodisperse silver nanoparticles without a size selection procedure. This environmentally friendly chemistry approach requires only three reagents (silver nitrate, sodium oleate and oleic acid) which all come from renewable resources. The average diameter of these nanoparticles can be greatly adjusted by varying reaction time and finely regulated by varying reaction temperature at the same precursor concentration. The nucleation/diffusional growth model can be used to interpret the size and morphology difference of silver nanoparticles synthesized under different conditions. Raman spectra of graphene with and without an active layer of silver nanoparticles were measured to investigate the surface-enhanced Raman scattering properties of the silver nanoparticles. The Raman signal of graphene with an active layer increased by fifteen-fold in comparison to that without an active layer. The surface-enhanced Raman scattering activity can be explained using interparticle coupling induced Raman enhancement.

Graphical abstract: Simple and green synthesis of monodisperse silver nanoparticles and surface-enhanced Raman scattering activity

Supplementary files

Article information

Article type
Paper
Submitted
09 Aug 2012
Accepted
25 Sep 2012
First published
25 Sep 2012

RSC Adv., 2012,2, 11404-11409

Simple and green synthesis of monodisperse silver nanoparticles and surface-enhanced Raman scattering activity

Z. Xu and G. Hu, RSC Adv., 2012, 2, 11404 DOI: 10.1039/C2RA21745G

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements